Casio CFX-9850G - Page 43

44
Chapter 3: Commands and Programming
Data Type 1 (REG)
The following are the parameter settings when the data type parameter set-
ting is 1: REG X data, REG Y data, X-data post-processing, Y-data post-
processing.
REG X Data Parameter
This parameter specifies which channel should be assigned as REG X data.
The initial default for this parameter is 0.
0 Highest channel of data send order
1 Channel 1 (CH1) data
2 Channel 2 (CH2) data
3 Channel 3 (CH3) data
4 SONIC channel data
5 Recorded time data
• Whenever REG X data is 5, you also have to use Command 3 to turn on
time data recording.
REG Y Data Parameter
This parameter specifies which channel should be assigned as REG Y data.
The initial default for this parameter is 0.
0 Second channel of data send order
1 Channel 1 (CH1) data
2 Channel 2 (CH2) data
3 Channel 3 (CH3) data
4 SONIC channel data
5 DIG IN channel data
X-Data Post-Processing Parameter
This parameter specifies the type of post-processing to be applied to data
output as REG X data. The initial default for this parameter is 0.
0 None (raw data)
1
d/dt (first derivative)
2
d
2
/dt
2
(second derivative)
Y-Data Post-Processing Parameter
This parameter specifies the type of post-processing to be applied to data
output as REG Y data. The initial default for this parameter is 0.
0 None (raw data)