26
Quick Start Basics
The following procedure describes how to shoot a single snapshot. For information
about shooting a series of shots (Continuous Shutter), see page 56.
1. Remove the lens cap and then press [r] (REC) to turn on the camera.
2. Set the mode dial to t (Single Shot).
3. Press [8].
4. Use [8] and [2] to select the top option in the
control panel (Exposure mode).
5. Use [4] and [6] to select t (Auto) and then
press [SET].
• You can use either monitor screen or viewfinder to
compose the image. Each press of the [EVF/LCD]
button cycles through the available monitor screen
and viewfinder on/off settings (page 158). If the
image in the viewfinder appears blurry, use the
diopter dial to adjust it.
To shoot a snapshot
[r] (REC)
Shutter button
Monitor screen
Viewfinder
Mode dial
[SET]
Diopter dial
[EVF/LCD]
[8] [2] [4] [6]
Snapshot mode icon
Remaining snapshot
memory capacity
(page 183)
To Next Page
Loading...
