62
Snapshot Tutorial
NOTE
• Note the following when selecting a High Speed CS speed (fps) setting.
– Use a higher High Speed CS speed (fps) setting when shooting a fast-moving
subject.
– Use a slower High Speed CS speed (fps) setting when shooting a slower-moving
subject.
• Note the following when selecting a High Speed CS maximum number of shots
setting.
– The greater the number of shots, the longer it takes to save them after shooting
is complete.
• Note the following when specifying a Prerecord CS shots setting.
– A setting that results in a Prerecord CS operation that takes at least 0.3 seconds
is recommended because there is a minimal lag from about 0.1 seconds to 0.3
seconds between the point you decide to shoot and the point that the shutter
button is fully depressed.
You can specify the method to use for saving images recorded with the following
continuous shutter (CS) modes.
Flash CS, High Speed CS
1. In the REC mode, press [MENU].
2. Use [4] and [6] to select the “REC” tab.
3. Use [8] and [2] to select “Save CS Images”, and then press [6].
4. Use [8] and [2] to change the setting.
Specifying the Method for Saving Continuous Shutter Images
Normal (Batch)
All images that were shot are saved after the continuous shutter operation is
finished.
To Next Page
Loading...
