60
Snapshot Tutorial
5. Set the mode dial to Õ (High Speed CS).
• This will display Š (High Speed CS).
6. Press [SET].
7. Use [8] and [2] to select the third control
panel option from the bottom (High Speed CS
fps).
8. Use [4] and [6] to select the continuous shutter
(CS) speed you want and then press [SET].
9. Use [8] and [2] to select the second control
panel option from the bottom (Max CS shots).
10.
Use [4] and [6] to select the maximum number of shots for each
continuous shutter operation and then press [SET].
11.
Use [8] and [2] to select the bottom control panel option (Prerecord
CS shots).
12.
Use [4] and [6] to specify how many of the 30 images and for how
long images should be pre-recorded in the buffer.
• Prerecord CS shooting is not performed when the number of buffer images and
the recording time are both zero.
• You can configure the mode so up to 29 images are pre-recorded to the buffer
until you fully press the shutter button.
1 to 40 fps
Enables specification of the number of
CS images recorded per second.
Shutter button full-press
Number of pre-record
images and pre-record
time
Number of remaining images
and remaining recording time
after the shutter button full-press
High Speed CS icon
CS speed
To Next Page
Loading...
