170
Appendix
The subject is out
of focus in the
recorded image.
The image may not be focused properly. When composing the
image, make sure the subject is located inside the focus frame.
The flash does not
fire.
1)If
?
(Flash Off) is selected as the flash mode, change to
another mode (page 42).
2)If the battery is low, charge it (page 16).
3)If a BEST SHOT scene that uses
?
(Flash Off) is selected,
change to a different flash mode (page 42) or select a
different BEST SHOT scene (page 63).
4)If Lag Correction is turned on while shooting single shots,
change the “Lag Correction” setting to “Ó Off” (page 40).
The ? (Flash Off)
icon flashes red on
the monitor screen
and the flash does
not fire.
The flash unit may be malfunctioning. Contact a CASIO service
center or your original retailer. Note that though the flash will not
fire, you still can use the camera for non-flash shots.
Camera powers
down during Self-
timer countdown.
The battery may be low. Charge the battery.
The monitor screen
image is out of
focus.
1)You may be using Manual Focus and have not focused the
image. Focus the image (page 79).
2)You may be using
´
(Macro) for scenery or portraits. Use
Auto Focus for scenery and portrait shots (page 79).
3)You may be trying to use Auto Focus or
)
(Infinity) when
shooting a close-up shot. Use the
´
(Macro) for close ups
(page 79).
There is digital
noise in images.
1)Sensitivity may have been increased automatically for a dark
subject, which increases the chance of digital noise. Use a
light or some other means to illuminate the subject.
2)You may be attempting to shoot in a dark location with
?
(Flash Off) selected, which can increase digital noise and
make images appear coarse. In this case, turn on flash (page
42) or use lights for illumination.
A recorded image
was not saved.
1)Camera power may have been turned off before the save
operation was complete, which will result in the image not
being saved. If the battery indicator shows , charge the
battery as soon as possible (page 18).
2)You may have removed the memory card from the camera
before the save operation was complete, which will result in
the image not being saved. Do not remove the memory card
before the save operation is complete.
Problem Possible Cause and Recommended Action
To Next Page
Loading...
Need help?
General
