137
Appendix
A recorded image
was not saved.
1)Camera power may have been turned off before the save
operation was complete, which will result in the image not
being saved. If the battery indicator shows , charge the
battery as soon as possible (page 18).
2)You may have removed the memory card from the camera
before the save operation was complete, which will result in
the image not being saved. Do not remove the memory card
before the save operation is complete.
Though available
lighting is bright,
the faces of people
in the image are
dark.
Not enough light is reaching the subjects. Change the flash
mode setting to
<
(Flash On) for daylight synchro flash (page
35), or adjust EV shift to the + side (page 42).
Night shots come
out bad.
Use the following BEST SHOT scenes (page 52) when shooting
at night.
• Night Scene (for shooting night scenery only)
• Night Scene Portrait (for shooting people against night
scenery)
Subjects are too
dark when shooting
images in a
seashore or ski
area.
Sunlight reflected by water, sand, or snow, can cause
underexposure of images. Change the flash mode setting to
<
(Flash On) for daylight synchro flash (page 35), or adjust EV
shift to the + side (page 42).
Digital zoom
(including HD
zoom) does not
work. The zoom
bar indicates zoom
only up to a zoom
factor of 3.0.
1)The digital zoom setting may be turned off. Turn on digital
zoom (page 65).
2)Date stamping may be turned on, which will cause digital
zoom to be disabled. Turn off date stamping (page 112).
The image is out of
focus during movie
recording.
1)Focusing may not be possible because the subject is outside
the focus range. Shoot within the allowable range.
2)The lens may be dirty. Clean the lens (page 124).
Problem Possible Cause and Recommended Action
To Next Page
Loading...
Need help?
General
Weight and Dimensions
