53
Advanced Settings
1. In the REC mode, press [MENU].
This will display the menu screen.
2. Use [4] and [6] to select the tab where the item you want to configure
is located.
3. Use [8] and [2] to select the menu item you
want, and then press [6].
4. Use [8] and [2] to change the setting.
5. After the setting is the way you want, press
[SET].
• Pressing [4] registers the selected setting and
returns to the menu.
• To configure settings on another tab after
pressing [
4] to return to the menu, use [8] to
move the highlighting up to the tabs, and then use
[
4] and [6] to select the tab you want.
. Menu Operations in This Manual
Menu operations are represented in this manual as shown below. The following
operation is the same one described under “Example Menu Screen Operation” on
page 52.
Settings
Example:
When “Focus” is
selected on the “REC”
tab
Tabs
Procedure
[r] (REC)
*
[MENU]
*
REC Tab
*
Focus
Use [4] and [6] to select the “REC” tab.
Use [8] and [2] to select the “Focus” and
then press [6].
Press [MENU].Press [r] (REC).
To Next Page
Loading...
Need help?
General
