19
Quick Start Basics
4. After charging is complete, disconnect the USB cable from the camera
and then unplug the power cord from the power outlet.
. To charge using a USB connection to a computer
The battery loaded in the camera is charged whenever the camera is connected
directly to a computer with the USB cable.
• Depending on the setup of your computer, you may not be able to charge the
camera’s battery over a USB connection. If this happens, use of the USB-AC
adaptor that comes with the camera is recommended.
IMPORTANT!
• The first time you connect the camera to your computer with the USB cable, an
error message may appear on your computer. If this happens, disconnect and then
reconnect the USB cable.
1. Press [ON/OFF] (Power) to turn off the camera.
2. With your computer turned on, connect the camera to it.
The camera’s back lamp will light red. After a short while, the camera will turn on
automatically and the back lamp will light amber to indicate that charging has
started. The back lamp will light green when charging is complete. Note,
however, that some computer models or connection conditions can produce low
supply capacity. If low supply capacity exists, charging will start without the
camera turning on. This is indicated by the back lamp lighting red. The back lamp
will go out in this case after charging is complete.
USB port
USB cable (included with camera)
Making sure that the 6 mark on the camera is
aligned with the 4 mark of the USB cable
connector, connect the cable to the camera.
[USB/AV] port
Large connector
Small connector
Terminal cover
To Next Page
Loading...
Need help?
General
