144
Using the Camera with a Computer
. To connect the camera to your computer and save files
1. Turn on the camera and press [MENU].
2. On the “¥ SETTING” tab, select “USB” and then press [6].
3. Use [8] and [2] to select “Mass Storage”, and then press [SET].
4. Turn off the camera and then
use the micro USB cable that
comes with the camera to
connect it to your Macintosh.
• For details about connecting to
the camera and precautions
when connecting, see page 19.
5. Turn on the camera.
The camera’s back lamp will light green or amber at this time. In this mode, your
Macintosh recognizes the memory card loaded in the camera (or the camera’s
built-in memory if it does not have a memory card loaded) as a drive. The
appearance of the drive icon depends on the Mac OS version you are using.
• The first time you connect the camera to your Macintosh with the USB cable,
an error message may appear on your computer. If this happens, disconnect
and then reconnect the USB cable.
6. Double-click the camera’s drive icon.
7. Drag the “DCIM” folder to the folder to which you want to copy it.
8. After the copy operation is complete, drag the drive icon to Trash.
9. Disconnect the camera from the computer.
After confirming that the back lamp is not flashing red, disconnect the USB cable.
USB
USB port
Micro USB cable
(included with camera)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
