EXAMPLE: RUN
RUN 100
RUN*Root
PARAMETERS:
1. Start line number: Interger in the rage of 1 ≤ line number ≤ 65535
2. Label: Name of a label in the program.. Entering an unknown label will
generate an “UL error”.
EXPLANATION:
1. Execution starts from the beginning of the program when the line number or
label name is omitted.
2. When the specified start line does not exist, the first line number above that
specified is taken as the start line number.
3. Variable and array values are not cleared.
4. This command cannot be used within a program.
5. This command cannot be used in the CAL mode.
TRON
PURPOSE: Specifies the trace mode.
EXAMPLE: TRON
EXPLANATION:
1. Switches the trace mode ON.
2. All subsequent program execution is accompanied by a display of the area
name and line number. The first two lines are displayed, and execution is
suspended.
3. The program stays in the TRON mode until TROFF statement is executed or
the power is switched OFF
SEE: TROFF
TROFF
PURPOSE: Cancels the trace mode.
EXAMPLE: TROFF
EXPLANATION: Cancels the trace mode (entered using the TRON statement).
SEE: TRON
To Next Page
Loading...
Need help?
General
