Casio Geometry User Manual

20060601
2-7
Drawing and Editing Objects
u To draw a polygon
1. Perform the following operation: 3(Draw) – C:Polygon.
2. Move the pointer to the location on the display where you want a vertex of the polygon to
be and then press w.
• Repeat this step as many times as required to specify the other vertices of the polygon.
3. To complete the polygon, move the pointer to the location of the fi rst vertex and then
press w.
Note
If you press J in place of step 3, the fi gure will be fi nalized as-is, resulting in an unclosed
non-polygon.
u To draw a regular n-gon
1. Perform the following operation: 3(Draw) – D:Regular n-gon.
• This displays a dialog box prompting you to specify the number of sides.
2. Input a value from 3 to 12 and then press w.
3. Perform steps 2 through 4 under “To draw a triangle” (page 2-5).
• This will draw a regular n-gon using the number of sides you specifi ed in step 2.

Casio Geometry Specifications

General

Brand	Casio
Model	Geometry
Category	Software
Language	English