— 10 —
MESSAGES
Table-5
Message Meaning Action
NO DATA! There is no data stored in memory. Store some data before trying to perform
this operation.
NOT ENOUGH
MEMORY!
There is not enough unused memory to
perform the operation.
Reduce the size of the data you are
trying to store or delete data already
stored to make room for the new data.
NOW PRINTING Printer is performing printing operation. Wait for printing operation to end.
NOW PRINTING CUT
THEN [SET]!
Printing is paused for a tape cut
operation.
Cut the tape and then press SET to
resume printing.
SAME NAME
ALREADY USED!
The name you are using when storing
data in memory is already used.
Use a different name or delete the data
in memory this is under the same name.
TEXT DOES NOT FIT! Text is too long to fit in the specified tape
length.
Reduce the size of the characters or
shorten the text.
TOO MANY LINES! Text has too many lines to fit on tape. Reduce the number of lines.
TOO MANY LINES
TO FRAME!
Text has too many lines to fit into a frame. Reduce the number of lines.
WHERE? Unit is asking for the starting point of the
operation you are performing.
Use and to move the cursor to the
starting point and press SET to specify it.
CANNOT COMBINE! Previously input text cannot be combined
with new input text.
Perform the operation and input new
text.
CANNOT USE 6 mm Current operation cannot be performed
using 6 mm tape.
Change to a different tape size.
CLEARS INPUT TEXT! The operation you have selected will clear
the text you previously input.
Proceed with the operation (and clear
the text), or press ESC to abort without
clearing anything.
DATA ERROR!
RESET!
Memory data has become corrupted for
some reason.
Reset the unit. Note that the reset
operation deletes all data in memory.
INITIAL? Memory initialization is required. Initialize memory.
INPUT TEXT! Unit is requesting input of text. Input the text you want to print.
LOW BATTERY Battery power is low. Replace batteries or use AC adaptor.
MEMORY FULL! Memory is full and data cannot be stored. Delete data you no longer need and
make room for new data.
To Next Page
Loading...
