— 2 —
CLEANING THE PRINTER HEAD AND ROLLER
1 : Make sure to turn the power switch off.
2 : Open the tape cartridge compartment cover.
3 : Remove the tape cartridge.
4 : Use a cotton swab dipped in alcohol to clean the printer head and roller.
5 : Replace the tape cartridge and close the compartment cover.
Figure-1
Figure-2
Press with a thin,
pointed object.
RESET switch
RESET OPERATION
If you experience serious malfunction of the unit or if operation fails completely, try performing the following
operation to reset the unit.
1 : Turn the power switch off.
2 : Open the tape cartridge compartment cover and remove the tape cartridge.
3 : Press the reset switch inside the tape cartridge compartment to reset the unit.
NOTE : 1. Take care not to press the RESET switch too hard with pointed object. Doing so can cause
malfunction.
2. Never press the RESET switch expect when the unit fails to operate correctly.
3. Data stored in memory is not cleared when you press the RESET switch.
To Next Page
Loading...
