E-9
Playing with Different Tones
414A-E-011A
Split Point
STRINGS GRAND PIANO 2
Adjusting the Volume of Layered Tones
1
While holding down the CONTROL
button, use the keyboard keys shown below
to adjust the volume of the layered tones.
+ : Raises the volume (0 to 24)
– : Lowers the volume (–24 to 0)
Assigning Different Tones to the Left
and Right Sides of the Keyboard
You can assign different tones to keys on the left side
and the right side of the keyboard.
1
Press the TONE button of the tone you want
to select for the high (right) range.
Example: GRAND PIANO 2
2
Press the SPLIT button.
• This causes the SPLIT indicator lamp to light.
3
Press the TONE button of the tone you want
to select for the low (left) range.
• The keyboard is now split between the two
tones.
Example: STRINGS
4
After you are finished using the split
keyboard, press the SPLIT button again to
unsplit it.
• This causes the SPLIT indicator lamp to go out.
▲
C1
▲
C2
▲
C3
▲
C4
▲
C5
▲
C6
▲
C7
▲
C8
–
+
Specifying the Keyboard Tone Split Point
1
While holding down the SPLIT button,
press the keyboard key where you want the
left limit of the high range (right) tone to
be.
• A note does not sound when you press a
keyboard key at this time.
NOTE
• The split point setting also controls the point where
the keyboard splits between the accompaniment
keyboard (pages E-13, 14) and the melody
keyboard. Moving the split point also affects the
sizes of the accompaniment keyboard and the
melody keyboard.
Using the Piano’s Pedals
The digital piano is equipped with two pedal jacks,
one for a damper pedal and one for a soft/sostenuto
pedal.
Low range
Left limit of the high range
High range
SP-3
To Next Page
Loading...
Need help?
General
