6
■
New targets are added to the controllers (pedals, wheel, knobs, and sliders)
New targets are added to the controllers (pedals, wheel, knobs, and sliders)New targets are added to the controllers (pedals, wheel, knobs, and sliders)
New targets are added to the controllers (pedals, wheel, knobs, and sliders).
..
.
Some additional targets (Zone On/Off, System Effect Bypass, Master Effect Bypass, Audio Volume and Layer1-6 On/Off) can be selected in the
controller edit menu (Knob1-4 Edit, Slider 1-6 Edit, Modulation Edit and Pedal1-2 Edit) in the Stage Setting Common Edit as follows.
Display Text Description Settings
Knob1 Edit >Ent
Parameter Group of K1 Edit (These are editable even if the
'Knob1 Enable' is set to Off.)
Zone On/Off: Controls On/Off of the Zone of which Knob1
Enable is set to On.
Off (0-63),
On (64-127)
Sys.Fx Bypass: Controls On/Off of the System Effect Bypass
Off (0-63),
On (64-127)
Mas.Fx Bypass: Controls On/Off of the Master Effect Bypass
Off (0-63),
On (64-127)
Audio Volume: Controls the play back volume level of the AUDIO
RECORDER
0 - 127
Target
Layer1-6 On/Off: Controls On/Off of the specific Layer in the Zone of which
Knob1 Enable is set to On.
Off (0-63),
On (64-127)
Knob2-4 Edit >Ent Same as 'Knob1 Edit >Ent' except the Knob number (2-4).
Slider1-6 Edit >Ent Same as 'Knob1 Edit >Ent' except the controller (Slider1-6).
Modulation Edit >Ent
Same as 'Knob1 Edit >Ent' except the controller (Modulation
Wheel).
Pedal1 Edit >Ent
Same as 'Knob1 Edit >Ent' except the controller (Pedal which is connected to
DAMPER/PEDAL1 Jack).
Pedal2 Edit >Ent
Same as 'Knob1 Edit >Ent' except the controller (Pedal which is connected to
/PEDAL2 Jack).
■
A Calibration function of Knobs is added.
A Calibration function of Knobs is added.A Calibration function of Knobs is added.
A Calibration function of Knobs is added.
Although the knobs which controls a parameter is set to center, if the value of a parmaeter is not set to middle of the range.
Calibrate the knobs with the procedure as follow.
1. Press the [SYS SETTING] button.
2. Select "General >Ent" and press the [ENTER] button.
3. Select "Knob Calibration >Ent" and press the [ENTER] button.
4. After a message “Set all knobs to the center.” is shown, set all knobs (K1-K4) to their center click position, and press the [ENTER] button.
5. After a message “Sure? No/Yes” is shown, press the [+/YES] button.
The calibration of center position of the knobs will be competed with these operations.
To Next Page
Loading...
