EN-2
■ To clear Bluetooth connection logs
• Performing the procedure below will clear the connection logs (pairing information) of all Bluetooth audio devices that have been
paired with the Digital Piano. If you are experiencing connectivity problems with Bluetooth audio devices, perform the procedure
below and then perform the procedure under “To pair the Digital Piano with a Bluetooth audio device” (page EN-1).
• After performing the procedure below, you should also clear the Digital Piano connection logs from all of the Bluetooth audio
devices that have been paired with the Digital Piano. For information about how to do this, refer to the user documentation of
each Bluetooth audio device.
1.
Hold down 3 FUNCTION.
2.
Press the E1 keyboard key.
This enters Bluetooth connection log clear standby, which is indicated by the Bluetooth icon ( ) flashing at high-speed.
• Step 3 below will execute the clear operation. If you want to cancel the clear operation at this point, release 3 FUNCTION
here.
3.
To execute the clear operation, press the C1 keyboard key.
• This will terminate the Bluetooth connection, which is indicated by the Bluetooth icon ( ) disappearing.
4.
Release 3 FUNCTION.
When you are playing audio from an external source through the Digital Piano’s speakers, you can adjust the volume level and
even perform center cancel, which cuts the vocal part. These operations are available for audio input using Bluetooth or the Digital
Piano’s bo AUDIO IN jack.
• For information about external input volume adjustment, refer to “Adjusting the Volume Balance” in the User’s Guide.
• For information about center cancel, refer to “Audio-In Center Cancel” in the User’s Guide.
External Input Volume Adjustment and Center Cancel
To Next Page
Loading...
Need help?
General
