— 13 —
4. Headphone check
1 Press “CONTROL” button.
*The confirmation chord of C4, E4 and G4 sounds.
2 Connect the headphone to the LEFT jack.
* “CHORUS” LED lights.
3 Remove the headphone from the jack.
* “REVERB” LED lights.
4 Connect the tuning meter to the RIGHT jack.
* “CHORUS” LED lights.
5 Press A4 key.
* Make sure that the tuning meter is set at 440 ± 2 cents.
6 Remove the tuning meter from the jack.
* “REVERB” LED lights.
5. MIDI IN/OUT check (If there is no MIDI cable, this check can be skipped)
1 Connect MIDI IN and MIDI OUT terminals with a MIDI cable.
2 Press “CONTROL” button.
*The confirmation chord of C4, E4 and G4 sounds.
3 Press “A4 KEY” button.
*The confirmation chord of C4, E4 and G4 sounds.
6. The diagnostic program ends.
“REVERB”, “MUSIC LIBRARY”, “LEFT/TRACK1”, “LEFT/TRACK2”,”TONE1” LEDs light.
“00” appears on the display.
To Next Page
Loading...
Need help?
General
