I-5
QT-6600 Installation & Down Recovery Manual
1-1-2. Remote IPL (from remote host to a terminal)
Before remote IPL, perform step 1 to 3.
1. Set the terminal as “FTP server”. (refer to 4-1-30. Program-
ming TCP/IP section of the programming manual on page 71.)
2. Insert vacant CF card (more than 128MB) to the CF card slot
of the target terminal.
3. Power on every peripheral devices and all terminals of the
cluster.
Do NOT operate the terminal until the IPL has completed.
After IPL completion, you can get the result of the IPL by PC
operation.
IPL source
LAN port
defined as FTP server
IPL target
IPL Data
PC
C
C
CF slot
To Next Page
Loading...
Need help?
General
