I-8
System Installation
1-2-4. The system with LAN printer
1. Set the printer ID No. (Printer ID No. is an unique number in
the cluster). (Refer to the UP-400 user’s manual)
2. Perform “System connection check” in the manager mode.
(Refer to 3-3-1. System connection check in the reference
manual.)
3. Set the pritner connection. (Refer to 4-1-13. Programming
printer connection in the programming manual.)
• In case of using printer by IP No., set the dip switch of the printer to “not to use
DHCP server” and set the IP No. (Also refer to the UP-400 user’s manual.)
• Please define one terminal controlling one LAN printer. In other words, do NOT
define multiple terminals controlling one LAN printer. Otherwise it will cause
printer error.
To Next Page
Loading...
