OTHER SETTINGS
135
IMPORTANT!
• Only a snapshot (JPEG) or movie (AVI) file can be
used as the power down image.
• Note that the power down image feature works only
with images recorded with this camera. The power
down image feature may not operate properly when
another type of image is specified as the power down
image.
• Formatting the camera’s flash memory deletes the
power down image (page 145).
• When both a still image and a movie are present for
the power down image, only the movie is used.
• Note that a power down image display operation
cannot be interrupted once it starts. Because of this,
you should select a relatively short movie when using
a movie file as the power down image.
■ To disable the power down image feature
1.
Use the USB cable to connect the camera to
your computer (page 162).
2.
Change the name of the current power down
image from ENDING.JPG or ENDING.AVI to
something else, or delete the current power
down image from flash memory.
To Next Page
Loading...
Need help?
General
