99
OTHER RECORDING FUNCTIONS
IMPORTANT!
• Note that the above histograms are shown for
illustrative purposes only. You may not be able to
achieve exactly the same shapes for particular
subjects.
• A centered histogram does not necessarily
guarantee optimum exposure. The recorded image
may be over-exposed or under-exposed, even
though its histogram is centered.
• You may not be able to achieve an optimum
histogram configuration due to the limitations of EV
shift.
• Use of the flash as well as certain shooting
conditions can cause the histogram to indicate
exposure that is different from the actual exposure of
the image when it was recorded.
• The histogram does not appear when you are using
Coupling Shot (page 89) or Pre-shot (page 91).
• The RGB (color component) histogram is displayed
for snapshots only. In the Movie mode, only the
luminance distribution histogram appears on the
monitor screen.
REC Mode Camera Settings
The following are the settings you can configure before
recording an image using a REC mode.
• ISO sensitivity • Grid on/off
• Metering • Image Review on/off
• Color filtering • Icon Help
• Sharpness • L/R key setting
• Saturation • Power on default settings
• Contrast • Resetting the camera
NOTE
• You can also configure the settings listed below. See
the referenced pages for more information.
— Size (page 70)
— Quality (page 71)
— White Balance (page 80)
— AF Area (page 74)
— Flash Intensity (page 65)
— Flash Assist (page 66)
— Digital Zoom (page 62)
To Next Page
Loading...
Need help?
General
