Casio SE-S10

— 27 —
DRAWER OPEN TEST[ 20 ]
[Function]
Tests whether drawers operate correctly.
[Operation]
Command:
n 0 9 1 SUBTOTAL
n: Number of times to run
0 Once
1 ~ 9 Inniteloop
● Ifyouselect“inniteloop”,thedrawerkeepsopeninguntilthestepisforciblyterminated.
● Toforciblyterminatethestep,press[C(Clear)]orturntheModeSwitchto[OFF].
[PRINT]
DRW 91
DRW OK
END 91
BUZZER TEST[ 21 ]
[Function]
Testswhetherbuzzersoundscorrectly.
The result of this test is not printed out. An operator must be present during this step to determine
the result.
[Operation]
Command:
n 0 9 2 SUBTOTAL
n: Number of times to run
0 Once
1 ~ 9 Inniteloop
● Ifacommandtospecifythenumberoftimestorunthetestisomitted,thetestisperformedonly
once.Ifyouselect“once”,one-shotbuzzersounds.
● Ifyouselect“inniteloop”,500-msecintermittentbuzzersoundsrepeatedly.
 Toforciblyterminatethestep,press[C(Clear)]orturntheModeSwitchto[OFF].
[PRINT]
BUZZ 92
END 92