Casio SE-S400 User Manual

E-78
Programming functions of departments and PLUs in a lump
There are two methods to set functions of departments or PLUs which are programming at once and
programming individual functions.
Programming department functions in a lump
This method programs function of a department at one time.
Step Operation
1 Turn the Mode switch to PGM position and select [System
Setting] then press F key.
>▪▪▪▪▪>F
2 Enter 3 and press o key to set the register in the
programming mode.
3o
3 You can skip this step if you program in departments 01
through 25. If you wish to program in departments 26
through 50, press
DEPT
SHIFT/
DEPT#
key.
DEPT
SHIFT/
DEPT#
4 Referring following table, input 12- digit program code.
BB▪▪▪▪▪BB
[Program code (12 digits)]
5 Press the department key you wish to program
!
For example, programming in dept. 26.
6 Repeat steps 3 through 5 if you wish to program functions
in another departments.
7 Press o key to complete the program.
o
Example:
Programming department 26 as;
• Normal item: D12 = 0.
• D11 through D8 must be 0000.
• US taxable status 1 (a = 1) and 2 (b = 2): D7 = 3 (1 + 2)
• Allowing zero unit price (a = 1), not allowing negative unit price (b = 0), hash item (c = 4): D6 = 5 (1 + 0 +
4).
• D5 must always be 0.
• Limiting minimum entry digit: 3 digits: D4 = 3.
• As this example is for setting functions in a department, D3 should be 0.
• Applying commission 1 (a = 1), not applying commission 2 (b = 0): D2 = 1 (1 + 0).
• D1 must always be 0.
Press 3o
DEPT
SHIFT/
DEPT#
00000350301!o
Advanced programmings and registrations

Casio SE-S400 Specifications

General

Clerk lock	Yes
Types of payment	Cash
Number of Price Look-Up codes (PLUs)	3000 PLUs
Supported paper width	58 mm
Display number of lines	10 lines
Display number of characters	26
Second display number of characters	20
RS-232 ports	2
Power source	AC
AC input voltage	100-240 V
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Depth	450 mm
Width	400 mm
Height	220 mm