Preparing the Stand
1. Loosen the tilt knobs by turning them
through at least 1 full rotation in the
directions shown.
2. Raise the upper part of the stand.
Then, while holding it steady, secure it
by tightening the tilt knobs one side at a
time in the directions shown.
+
Always loosen the tilt knob when moving the stand. Moving without loosening the tilt knob
will result in malfunction.
3. Remove the rear cover by pressing at
the locations marked “A” and sliding in
the direction of the arrow.
A
A
To Next Page
Loading...
Need help?
General
