Casio WK-3000 User Manual

E-54
Creating a User Tone
Use the following procedure to select a preset tone and change
its parameters to create a user tone.
1 First, select the preset tone you want to use as a
basis for your user tone.
2 Press the SYNTH button.
• This enters the Synthesizer Mode, which is indicated
by the pointer next to SYNTH on the display screen.
3 Use [왗] and [왘] CURSOR buttons to display the
parameter whose setting you want to change.
• Each press of [왗] or [왘] CURSOR button changes to
the next parameter. See “Parameters and Their
Settings” on this page for information on setting range
for each parameter.
4 Use [+] and [–] to change the setting of the currently
selected parameter.
• You can also use the number buttons to input a value
to change a parameter setting. See “Parameters and
Their Settings” on this page for information on setting
range for each parameter.
5 After you are finished editing the sound, press the
SYNTH button to exit the Synthesizer Mode.
NOTE
• See “Storing a User Tone In Memory” on page E-57 for
details on saving user tone data to memory so it is not
deleted.
Synthesizer Mode
735A-E-056C
Atk Time
Currently selected parameter
Parameter setting value
y
V i bDe l a
Parameters and Their Settings
The following describes the function of each parameter and
provides its setting range.
■ Attack Time (Range: –64 to 00 to +63)
Time it takes before the tone sounds after a key is pressed
■ Release Time (Range: –64 to 00 to +63)
Time the tone continues to sound after a key is released
■ Cutoff Frequency
(Range: –64 to 00 to +63)
High-band cutoff for the harmonic components of the tone
■ Resonance (Range: –64 to 00 to +63)
Resonance of the tone
Atk Time
Re l . T ime
q
C-of fFr
.
Resonan
SYNTH
CURSOR
[+]
/
[–]
MODULATION button lamp
●WK-3100/WK-3000
WK3100_e_47-58.p65 04.3.26, 0:11 PM54

Casio WK-3000 Specifications

General

Brand	Casio
Model	WK-3000
Category	Electronic Keyboard
Language	English