E-88
4
Use the [왗] and [왘] CURSOR buttons to display
the screen for the type of operation you want to
perform.
• See the pages referenced below for details about using
each of the above menu operations.
Loading a file (Crd Load): page E-90
Saving a file (Crd Save): page E-88
Renaming a file (Crd Rename): page E-91
Deleting a file (Crd Delete): page E-92
Formatting an SD memory card (Crd Format)
:page E-93
5
Press the [왔] CURSOR button to advance to the
next operation screen of each menu.
Basic Floppy Diskette Operation
(WK-3800 Only)
1
Insert a floppy diskette into the keyboard’s floppy
disk drive.
2
Press the DISK/CARD button.
• This causes a pointer to appear next to the DISK/
CARD on the display, and also displays “Disk” in the
display’s text area.
3
Perform the same operations as those starting from
step 3 of under “Basic Memory Card Operation”
on page E-87.
• Note that Disk Mode operations are indicated on the
display by the prefix “Fd” in place of the “Crd” prefix
of the Card Mode operations.
Sa ve
Lo ad
Re name
De lete
Fo rma t
[왗]
[왘]
[왗]
[왘]
[왗]
[왘]
[왗]
[왘]
Saving Files
You can use the procedures in this section to save Song
Memory, Synthesizer, and other data you create to external
storage media for later loading when you need it. See
“Savable File Types” on page E-83 for information about the
type of data you can save.
PREPARATION
• SD Memory Card
• Insert a memory card that has been formatted on the
keyboard into the keyboard’s card slot. Make sure that
the write-protect switch of the memory card is not in
the write-protect position.
• Floppy Diskette (WK-3800 Only)
• Insert a properly formatted floppy diskette into the
keyboard’s floppy disk drive. Make sure that the
diskette’s write protect hole is closed, which enables
writing.
NOTE
• Depending on the type and the amount of data involved
and type of media you are using (SD memory card or
floppy diskette*), a data save or load operation can take
anywhere from a few minutes to more than 30 minutes
to complete. The message “Pls Wait” will remain on the
display to indicate that a data save or load operation is
being performed.
* WK-3800 only
IMPORTANT!
• Never try to perform any operation while “Pls Wait” is
displayed. Performing any operation can cause Flash
memory, or memory card or floppy diskette data to be
deleted, and damage the keyboard’s memory and cause
it to malfunction.
To save a file to external storage media
1
What you should do first depends on the type of
external storage media you are using.
• SD Memory Card
On the WK-3800, press the DISK/CARD button twice.
On the WK-3300/WK-8000, press the CARD button
once.
• This causes the CARD indicator (the DISK/CARD
indicator on WK-3800) to appear on the display, and
also displays “Card” in the display’s text area.
• Floppy Diskette (WK-3800 Only)
Press the DISK/CARD button.
• This causes the DISK/CARD indicator to appear
on the display, and also displays “Disk” in the
display’s text area.
Saving Data
To Next Page
Loading...
Need help?
General
