To display your route, use the procedure below to change “Route Display” on
the setting menu from “OFF” (initial default setting) to “ON”.
1.
While the map is displayed, swipe the touch screen from
bottom to top. On the menu that appears, tap “Settings”.
2.
Scroll the setting menu downwards. After confirming
that the “Route Display” setting is “OFF”, tap to change
it to “ON”.
Important!
●
This watch acquires location information at regular intervals and tracks your
route on a map. To conserve battery power, the frequency of GPS
information acquisition is normally low. Because of this, the route tracking
displayed while you are traveling by car, train, or other higher speed mode
of transportation may appear rather rough. Very high-speed transportation
may make it impossible to obtain GPS information and display route
correctly.
●
If you want smoother route display, start a data measurement operation with
the Activity app. GPS information is acquired more frequently during an
Activity app data measurement operation, so this will make the route display
smoother.
●
The watch saves route information, marks, memos, and other data in
internal storage. Data is retained as long as memory capacity is available.
When memory becomes full, the watch automatically deletes the oldest
data to make room for newly recorded data.
EN-27
To Next Page
Loading...
Need help?
General
