35
To auto project images files or a movie file from projector
internal memory
1.
Perform steps 1 through 8 under “To copy files from a computer to projector
internal memory” (page 19).
2.
Create a folder named “AUTORUNC” (all single-byte upper-case characters) in
the root directory of the “InternalMem” drive (projector internal memory).
3.
Insert all of the image files or movie file you want to project with Autorun into the
folder you created in step 2.
z If you want to auto project a movie file, place only one movie file into the “AUTORUNC” folder.
Do not place any other files into the folder. If there is both a movie file and image file in the
“AUTORUNC” folder, the image file will be given priority and the movie file will not be played.
z Multiple image files can be placed in the “AUTORUNC” folder without any problem. If there
are, turning on projector power in step 6 below will start a slideshow of the images.
4.
Turn off the projector.
5.
If a USB flash drive or some other USB device is connected to the projector’s
USB-A port, disconnect it.
6.
Turn on the projector.
z This will automatically project the file(s) you put in the AUTORUNC folder in step 3 above.
To Next Page
Loading...
Need help?
General
