14
To select the input source
1.
Press the [INPUT] key. This will display the “Input” dialog box.
2.
Depending on the input source, perform one of the operations described in the
table below.
z The name of the input source you selected will appear in the upper right corner of the
projection screen for a few seconds.
z The message “No signal input” will appear if no input signal can be detected.
Note
z For more information about the operation required to select Network, USB Display, File
Viewer, or CASIO USB Tool as the input source and perform projection, refer to the following.
Resolution
The projector’s video resolution is fixed at WXGA (1280 × 800 pixels). Images may appear coarse, text
and other figures may be difficult to read or a moire pattern may appear when the input signal from a
computer does not match the projector’s video resolution. If this happens, try doing the following.
z Change the computer’s output resolution setting so it matches the projector’s video resolution.
For information about the video resolution of your projector, see “Specifications” in the Setup
Guide. See the user documentation that comes with your computer for details about changing its
settings.
z Change the “Aspect Ratio” setting to “True”. With the “True” setting, the projector projects the input
signal at its actual size (1 input source dot equal to one projector output pixel dot).
For information about configuring the Aspect Ratio setting, see “To change the aspect ratio of the
projected image (ASPECT)” (page 49).
To select this input source: Perform this operation:
Computer 1, Computer 2, Video,
S-Video, HDMI, Network, USB Display
Use the [T] and [S] keys to select the name of the input source you
want to select and then press the [ENTER] key.
File Viewer 1. Use the [T] and [S] keys to select “Viewer” and then press the
[ENTER] key.
2. On the dialog box that appears, confirm that “File Viewer” is
selected and then press the [ENTER] key.
CASIO USB Tool 1. Use the [T] and [S] keys to select “Viewer” and then press the
[ENTER] key.
2. Press the [T] key to select “CASIO USB Tool” and then press the
[ENTER] key.
Network: Separate Network Function Guide
USB Display: “Projecting with the USB Display Function” (page 41)
File Viewer: “Projecting with File Viewer” (page 17)
CASIO USB Tool: “Projecting the Screen Image of a Graphing Calculator” (page 46)
To Next Page
Loading...
Need help?
General
