To Next PageTo Next PageWhy isn't the SSID of my Casio Projector showing up on the Projector List?
If the SSID of the projector you want to connect to isn't on the Projector List dialog box, check the “SSID Broadcast” setting on the projector. If it's set to “Disable”, change it to “Enable”. Also, make sure the projector is turned on.
What to do if [Reconnect] remains on the Wireless Connection 3 window and my computer won’t connect to the Casio XJ-H1750 Projector?
If the [Reconnect] status persists in Wireless Connection 3 and your computer fails to connect to the Casio Projector, consider the following: * Close any wireless LAN utilities other than Wireless Connection 3 that are running on your computer. * Ensure that the projector and computer are in close proximity and without obstructions. Move them closer or remove any walls or impediments. * Relocate any nearby devices that could interfere with the wireless LAN signal, such as microwave ovens or Bluetooth devices. * Verify that the projector is turned on and that its wireless adapter is properly connected. * Enable the computer’s wireless LAN function, ensuring it meets the minimum system requirements for Wireless LAN.
General| Brightness | 4000 ANSI Lumens |
|---|---|
| Technology | DLP |
| Projection System | DLP |
| Lamp Type | UHP |
| Throw Ratio | 1.5 - 1.8:1 |
| Input Terminals | HDMI, VGA, Composite, S-Video |
| Output Terminals | Audio Out |
Details key projector features including light source, input options, 3D support, and direct power-on.
Explains how to enable and configure the projector's 3D projection capabilities.
Covers adjusting image brightness, color modes, and aspect ratio for optimal viewing.
Describes the Eco Mode options for power saving, low noise, and balancing projection brightness.
Covers navigating the setup menu, displaying, and configuring various projector settings.
Explains how to enable automatic projector power-up when connected to a power source.
Instructions for setting up, changing, and managing the projector's password for access control.
How to reset settings for individual main menus to their factory defaults.
Explains error messages and indicator light patterns for troubleshooting projector issues.
Instructions for establishing a wired LAN connection and controlling the projector via a computer.
