• IP address Specifies the controller IP address.
• IP ID Specifies the controller IP ID.
• Port Specifies the number of the port being used. (Always 41794)
Enter the applicable information for each item and then click the [Send] button. This will restart
the network function and apply the new settings.
AMX
This Projector supports the AMX controller and Device Discovery. Commands used for control are
PJLink standard commands.
For detailed information, visit the website below.
URL: http://www.amx.com/
Caution
• The Projector can be configured to enable or disable power-on via wired LAN during the
standby state. To do so, use [Network Standby] of the Projector's Setup Menu.
Enable Network Standby Mode
: When this setting is set to "On", the network standby
function is enabled and you can power on the projector via wired LAN. However, when the
time set in "Auto Disable Network Standby Mode" below has elapsed after entering the
standby state, the network standby function will be invalid. In that case, turn on the power
with the remote control or the projector unit key.
Auto Disable Network Standby Mode
：Set a period of time from when the projector enters
the standby state until when the network standby function becomes invalid.
To Next Page
Loading...
Need help?
General
