Cassida 6600 User Manual

Cassida Corporation • 11035 Technology Place, Suite 500 San Diego, CA 92127 • www.CassidaUSA.com
©2019 Cassida Corporation. All rights reserved. Specifications subject to change without notice. Cassida is a registered trademark of the Cassida Corporation.
REV0919
6600
Feed Gap Procedure
STEPS
We recommend following the steps below to properly adjust the feed gap of 6600.
The Cassida 6600 feed gap adjustment dials can be sensitive during adjustments. Do not overturn each adjustment or
you may overshoot the optimum gap. We recommend testing with a stack of bills after each adjustment turn.
1. Turn the power switch off and disconnect the power cord from the machine.
2. Place two moderately worn $1 bills on the hopper platform lengthwise, centered on the platform, and approximately
one inch apart.
TOOLS NEEDED
NOTE:
To clean the unit, it is recommended
to use Cassida cleaning products.
Philips screwdriver
Feed gap adjustment of the unit is always performed before shipment. Sometimes during transit or after a long
period of use the feed gap might change. Feed gap that is not correctly adjusted can affect the overall
performance of the Cassida 6600, which can lead to a variety of issues such as multiple bills at the same time
being pulled into the bill feed mechanism, jamming, miscounting, and Double Note (DBL) Errors.

Cassida 6600 Specifications

General

Stacker Capacity	200 notes
Power Supply	AC 100-240V, 50/60Hz
Display Type	LCD
Batching	Yes
Add Function	Yes
Power Consumption	60W
Noise Level	≤60dB
Counterfeit Detection	UV, MG, IR
Hopper Capacity	500 notes
Dimensions	290 x 320 x 240 mm
Error Detection	Double note detection, chain note detection, half note detection

Summary

Feed Gap Procedure

Tools Needed and Preparation

Identifies required tools like a Philips screwdriver and initial preparation steps.

Positioning Test Bills

Instructs on placing two $1 bills on the hopper platform for testing.

Advancing Bills into Feed Path

Details manually turning the feed roller shaft to pull bills into the path.

Testing Bill Resistance

Explains how to check for moderate and equal resistance by tugging bills.

Adjusting Feed Gap Screws

Provides guidance on turning adjustment screws to achieve optimal feed gap.

Troubleshooting Adjustment Issues

Offers solutions for bills feeling too loose or too tight during adjustment.

Causes of Jams and Misreads

Lists common factors leading to jams or incorrect bill recognition.

Contact and Support Information

Provides contact details for Cassida Corporation's technical services.