Cassida Corporation • 11035 Technology Place, Suite 500 San Diego, CA 92127 • www.CassidaUSA.com
©2019 Cassida Corporation. All rights reserved. Specifications subject to change without notice. Cassida is a registered trademark of the Cassida Corporation.
REV0319
6600
Cleaning Procedure
Like other bill counters on the market, standard maintenance and cleaning of the unit are important and
recommended to significantly prolong the lifespan of the product. Cleaning the unit helps prevent issues that may
lead to costly repairs. Dirty sensors can affect the overall performance of the Cassida 6600, which can lead to a
variety of errors like genuine bills being rejected. We at Cassida suggest performing weekly cleaning on the unit to
maintain top performance.
STEPS
We recommend the user follows the steps below to properly clean your 6600.
1. Turn the power switch off on the unit and disconnect the power cord from the machine.
2. Clean the dust from the machine using an air duster. Spray the air duster from left to right in the following three
areas as shown below. Start with spraying the hopper, proceed next with spraying the inside of the unit, and
then finally finishing with spraying the stacker.
* Be cautious and keep the nozzle 1-2 inches away from the unit at all times.
TOOLS NEEDED
A. HOPPER C. STACKER
NOTE:
To clean the unit, itʼs recommended
to use Cassida CleanPro Cleaning
Kit that includes:
- 1 Cassida Air Duster
- 1 Cassida Dust Cover
- 5 CleanPro Cleaning Swabs
- 5 CleanBill Pro Cleaning Cards
B. INSIDE
Air Duster Cleaning Cotton Swab Cleaning Card
To Next Page
Need help?
General
