moving money forward
Ensure the hopper and stacker are empty. Attach power cable to rear of the machine, plug into
a three-prong outlet and turn the power switch, located on the rear of the machine, to the ON position.
The unit will load and conduct a power-on self-test (POST). The screen will display “0” in all counting
fields when the unit is ready to operate.
In order to avoid jams and ensure proper operating speed of the machine, it is important to load
the hopper correctly. Cassida recommends to not use more than 500 bills at a time and change to
MANUAL mode until the technique of loading bills is mastered. Follow the 3-step loading technique
below to ensure smooth bill feeding.
1. Make a Stack
Correct or remove bills that are severely wrinkled, damaged or folded. Square the bill stack.
2.1 Powering Up
2.2 Loading the Hopper
GETTING STARTED
2.
10
To Next Page
Loading...
Need help?
General
