REGULAR MAINTENANCE
WARNINGS
Regular maintenance work can be carried out by non-specialised personnel who, however, must always
adhere to the instructions given in this manual. Before cleaning or servicing the chiller lock-off the power
supply. When carrying out regular maintenance work do not remove any of the safety guards.
CLEANING THE CHILLER AND ACCESSORIES
Before using this Chiller clean on the inside and all the accessories. Use warm water and neutral soap.
Rinse and dry well. Do not use solvent or powder based detergents and use a silicon wax to protect the
steel.
PERIODICALLY CLEANING THE CONDENSER
The condenser should be cleaned periodically. Cleaning intervals will depend on how frequently it is
used.
MEASURES TO TAKE WHEN OUT OF SERVICE FOR A PERIOD OF TIME
When the Chiller is out of service for a long period of time take the following measures:
• Remove the plug from the power socket;
• Remove all food and clean the inside of the Chiller and all accessories;
• Buff all the stainless steel surfaces with a cloth moistened with vaseline oil to give a protective
coating;
• Leave the door ajar for air circulation to prevent bad odours;
• Periodically air the room or kitchen where the Chiller is installed.
CAUTION: To access the condenser (please refer to page 16 in the spare parts catalogue) it is
necessary to remove the safety guards. Always use qualified and specialised personnel.
To guarantee efficiency and performance in time, it is necessary to clean the condenser periodical-
ly. It is highly recommended if located in dusty environments to clean the louvers on the refrigerat-
ing unit once a month and once every three months if located in closed and clean environments. To
remove dust and dirt from the louvers use a brush or vacuum cleaner. Do not use sharp objects or
tools that could damage the condenser. Do not clean using water jets.
3
To Next Page
Loading...