CATO Socket X1700 - Creating a Site in Cato Management

To Next Page

To Previous Page

Creating a Site

Create a site in the Cato Management Application for the site where you are deploying your new

Socket.

If you are using an add-on hardware card with additional network interfaces for the Socket, this add-on

is configured after the site is created. For more information, see Configuring Add-ons for the X1700

Socket [7].

Note: If the add-on was not pre-ordered and installed by Cato, you must restart the

Socket after the add-on is installed.

To create a new Socket site:

1. Log in to the Cato Management Application.

2. From the navigation menu, click Network > Sites.

3. Click New. The Add Site panel opens.

Socket X1700 Deployment Guide Creating a Site

Page 5 of 18