CBM CEL-200 - Page 4

4
CEL-200 Menus and Settings:
System Config:
Language: ( Fr / En )
Selects the system language, in french (fr) or in english (en)
Mode: ( Master / Slave )
Selects the operating mode. In master mode, the system controls the light outputs
according to the programmed schedule. In slave mode, the light outputs level is set
according to the 0-10V input voltage.
Contrast:
Adjusts the LCD display contrast. low value = very light, high value = very dark. A
contrast of 10 to 16 should be optimal for this LCD display model.
Brightness: ( 30% - 100% )
The brightness of the LCD backlighting.
Manual Timer: ( 0 - 60 minutes )
The number of minutes before manual mode reverts back to automatic mode. In case
the user forgets to turn the system back to automatic mode, this security function
guarantees that the automatic mode will become active after this amount of time. Set
to 0 to deactivate this function.
Chromatic Mode: ( Yes / No ) - (Optional)
Chromatic mode allows to control bi-colored lights.
Kelvin at x%: ( 2000K - 7000K ) - (Optional)
The Kelvin set point according to the voltage of the 0-10V input in slave mode when
chromatic mode is on. Lets you adjust Kelvin values for different light level.
Clock Menu:
Lets you adjust the time and rearing day. Use the up / down arrows or the multifunction
rotary buttons to adjust the time. Use the left / right arrows to adjust the rearing day.
Press the timer button to reset the rearing day to 0.
Info Menu:
This screen shows system information, like the software version and the frequency
detected by the CEL-200 (50 - 60 Hz). This information can be useful for
troubleshooting purposes.