6
Edit Period Menu
After selecting a period to edit, the following screen is shown:
Step: The first number is the selected step. The second number is the total number of
steps in this period.
Time: The time at which this step will be executed.
Level: The light level to apply for this step.
Kelvin: The color of the lighting for this step. Chromatic mode only.
Add Step: To add a step to the period. Inserts a new step after the selected step. In
the above example, with step 1 selected and a total of 2 steps, adding a step would
place it at position 2, shifting all following steps by 1 position so the old step 2 would
become step 3 and so on.
Delete Step: To remove a step from the schedule. Deletes the selected step. In the
above example, step 1 would be deleted and step 2 would become step 1.
Notes on steps time adjustment:
The time for a step cannot be adjusted past the time of the previous and next steps. If
for example you have 3 steps with step 1 at 08h00 and step 3 at 18h00, step 2 cannot
be adjusted earlier than 08h00 and no later than 18h00. If you want to set step 2 time
at 18h30, you’ll first need to set step 3 to 18h30 or later.
End of Schedule:
The last period in the schedule will repeat indefinitely, even is the number of days has
been reached. Because sometimes you need to keep going for just a few more days at
the end of the rearing period.
>
Edit Period
Step: 1/2
Time: 2:00
Level: 10%
Kelvin: 2000
Add Step
Delete Step
Back
To Next Page
Loading...