24
Connecting to the Mains Water Supply
• Fit the seal included in the hose packing at the end of the
water inlet hose on the tap side.
• Connect the water inlet hose to a 3”/4, threaded water tap,
then securely tighten the connecting nut by hand.
• After connections are completed, check for leaks at the
connection joints by turning the tap full on.
For your washing machine to work properly, the mains water
pressure must be between 0.1 and 1MPa (0.1 - 10 bar).
Drainage Connection
• It is recommended that
you have a fixed drainage
outlet 60 to 70cm from the
floor.
• Avoid the drain hose
being too tight, kinked or
restricted.
• The water outlet can
either be connected to a water drain or to a sink outlet
spigot. This connection should be a minimum of 60cm and
a maximum of 100cm from the floor.
• The drain hose should be no longer than 4m in length to
ensure good performance from the washing machine.
• After connecting the water supply, check to ensure there
are no leaks.
The drain hose must be securely fastened to the outlet to
prevent any risk of the drain hose becoming detached and
causing flooding.
Once the appliance is connected to the water supply and the
drain connection, ensure that the water inlet and drain hoses are
not folded, twisted, crushed or elongated by stretching when
moving the appliance into position.
To Next Page
Loading...
