What to do if my CDA CI981 is not draining water?
If your CDA washer isn't draining water, check these potential issues: * The drain hose could be obstructed or bent, so inspect the drain hose. * The pump filter might be obstructed, so clean the pump filter. * The drain hose may be positioned above 100cm; install it at the specified height of 80-100cm.
What to do if my CDA CI981 won't start?
If your CDA Washer won't start, there are several possible reasons: * It might be unplugged, so insert the plug into the socket. * The fuse could be damaged, in which case you should replace it. * There may be a fault with the power supply, so check the power supply. * The washer door might not be properly closed, so ensure that it is. * The “Start / Pause” button may not have been pressed, so press the “Start / Pause” button.
Why is my CDA Washer vibrating so much?
If your CDA washer is vibrating, consider the following: * Ensure all transit bolts have been removed. * Make sure the machine is located on an even surface and is correctly leveled. * Avoid overloading the machine, and ensure clothes are loaded evenly. * Confirm that the machine is installed away from other objects. Sometimes, a small load can also cause vibration, but this is not indicative of a fault.
Why is my CDA CI981 not filling with water?
If your CDA washer is not filling with water, consider the following: * Ensure the “Start / Pause” button has been pressed. * Check that the water tap is turned on. * Verify the water pressure is adequate. * Inspect the inlet hose for any kinks. * Confirm there is no water supply failure. * Make sure the programme knob is set correctly. * Ensure the washer door is properly closed. * Check if the inlet hose filter is blocked and unblock it if necessary.
What to do if my CDA Washer stops before completing its wash cycle?
If your CDA washer stops before completing its wash cycle, check the power and water supplies for any failures.
Why is my CDA Washer failing to spin?
If your CDA washer is failing to spin, it may be due to an unbalanced load. Try adding more clothes or running the spin cycle again.
What to do if my CDA Washer is draining while being filled?
If your CDA washer is draining while it's being filled, it could be due to: * The height of the drain hose being below 80cm. Install the drain hose at the specified height of 80-100cm. * The drain hose being in water. Ensure the drain hose end is not immersed in water.
Why is there excessive foam in my CDA Washer drum?
If you observe excessive foam in your CDA washer drum, this may be caused by: * The detergent not being a low foaming type. Check if the detergent is suitable. * Using an excessive amount of detergent. Reduce the amount of detergent used.
What to do if my CDA Washer operation stops for a period of time?
If your CDA washer operation stops for a period of time, it might be due to the following: * The machine giving an error message. Check display codes. * The machine being in a soaking cycle. Press the “Start / Pause” button again to cancel it. Consider a drain cycle.
Why is my CDA Washer not drying?
If your CDA washer is not drying, leave the appliance off, to cool for a while before trying again. If still not drying performance, contact CDA Customer Care.
Instructions for removing the four transit bolts located at the rear of the appliance before use.
General| Colour | White |
|---|---|
| Spin Speed | 1400 rpm |
| Wash Load | 8 kg |
| Capacity | 8 kg |
| Weight | 68 kg |
To Next Page
