29
Display and failure codes
Your machine is equipped with diagnostic systems which monitor
wash progress and will intervene to protect the machine in the event
of a fault.
Should any of the above potential solutions not resolve the fault;
• Unplug the machine.
• Close the water tap.
• Contact CDA Customer Care.
Fault code Cause Potential solution
Door is not closed
properly
Water injection
problem
Overtime whilst
draining
Water overflow
Other
Restart cycle after the door is closed. Switch appliance
o and on if necessary. Check no clothes are blocking
the door.
Check if water pressure is too low or high.
Straighten the inlet hose.
Check if the inlet valve filter is blocked (page 22-23).
Check if the drain hose is blocked.
Restart the appliance.
Restart the appliance and try again. If this code still
shows please contact CDA Customer Care to arrange a
service visit. Contact details are on the rear cover of this
manual.
To Next Page
Loading...
