32
Installation
This install is to be carried out by a minimum of two competent
personnel. Always wear adequate PPE (Personal Protective
Equipment) such as gloves and safety boots and familiarise
yourself with your environment’s hazards.
Transit bolts, located at the rear of
the appliance, must be removed
prior to using the appliance to
prevent damage. There are four in
total.
• Remove the back cover from the machine.
• Loosen the transit bolts using a suitable spanner by turning them
anti-clockwise and then remove them.
• Remove the bolts and plastic spacers that were retained by the
transit bolts.
• Cover the bolt holes with the plastic plugs supplied.
Do not throw the transit bolts or plastic spacers away. If you need
to move the machine after installation you should first replace the
transit bolts and spacers.
Do not install your machine on rugs or similar surfaces.
For your machine to work quietly and without any vibration, it should
be installed on a flat, non-slippery and solid surface.
The machine must be positioned on a solid support, such as the bare
Fig. 15
To Next Page
Loading...
