33
floor or a well-fitting riser, ensuring the machine is unable to fall when
subjected to the typical vibrations generated by a machine.
The machine must not be fitted near heat sources, nor near
combustible materials such as coal or gas. Ensure that the power cord
is not trapped in any way.
Levelling
To reduce the noise from the
machine and to prevent unnecessary
movement during use, ensure the
machine is level, using the adjustable
feet.
First, fix and level the rear feet. When
they are properly fixed, secure the
metal locknut tightly against the underside of the machine.
• Put the machine into its required position.
• Then level the front feet in the same way as the rear feet.
Please note: Raising the machine too high can aect the stability
of the appliance.
Do not use wooden blocks, packaging or any similar means to
stabilise the appliance. Use only a flat, solid surface and the
appliance’s feet.
Fig. 16
To Next Page
Loading...
