CDA ci371 - User Manual

Questions and Answers

M
Michael Peterson DVMAug 13, 2025
What to do if my CDA ci371 Washer won't pump out water?
- N
  nicoleromanAug 13, 2025
  If your CDA Washer isn't pumping out water, make sure the drain hose is not kinked and the drain pump is not blocked.
F
Faith ButlerAug 16, 2025
What to do if my CDA Washer is not filling with water?
- T
  Travis DorseyAug 16, 2025
  If your CDA Washer is not filling with water, ensure that the plug is properly connected to the socket, the door is securely closed, the water tap is turned on, the water intake hose filters are not blocked, and the water intake hose is not trapped or kinked.
A
Austin SmithAug 20, 2025
Why is my CDA ci371 Washer vibrating so much during spins?
- N
  Nicole SimmonsAug 20, 2025
  Strong vibrations during spins can occur if the appliance is not properly leveled, is too close to walls or cupboards, or if the transit bolts haven't been removed, or the drum is otherwise locked in position. Ensure the CDA Washer is correctly leveled and not touching any surrounding surfaces. Also, check that all transit bolts have been removed and the drum is free to move.
C
cphillipsAug 25, 2025
What to do if my CDA ci371 Washer has excessive foam in the drum?
- J
  James MossAug 25, 2025
  Excessive foam in the drum of your CDA Washer, possibly flowing out of the drawer, suggests that the detergent used may not be recommended for automatic washing machines, or that too much detergent has been used. Make sure that the detergent used is suitable for automatic washing machines and that the quantity of detergent used does not exceed the amount stated in the manual.
P
Penny PayneAug 28, 2025
Why is my CDA Washer leaking water on the floor?
- J
  Jessica BurnsAug 28, 2025
  If you find water on the floor near your CDA Washer, check that the water intake hose fittings are not loose and that the end of the drain hose is correctly positioned.
A
Aaron McculloughAug 31, 2025
Why does water enter and pump out of my CDA Washer continuously?
- V
  Veronica SmithAug 31, 2025
  If water enters and pumps out of your CDA Washer continuously, the end of the drain hose might be too low down. Check the position of the drain hose.
C
carlsonlauraSep 4, 2025
What to do if the aqua stop device tripped in my CDA ci371 Washer?
- B
  Brian RiveraSep 4, 2025
  If the aqua stop device tripped in your CDA Washer, cut off the power supply, turn off the water tap and contact CDA Customer Care.
H
Herbert MoranSep 8, 2025
Why is there too much water left in the compartment of my CDA Washer?
- J
  Jamie SandersSep 8, 2025
  If not all fabric conditioner is used or there is too much water left in the compartment of your CDA Washer, the detergent drawer syphons are probably incorrectly fitted or blocked. Check that the detergent drawer syphons are correctly fitted and not blocked.