18
2 Programmes can also be interrupted by turning the
“Programme Selector” knob while the cycle is in
progress.
3 To change the washing programme, simply turn the
“Programme Selector” to select the new programme;
there is no need to set the appliance in pause status.
The new cycle will be carried out completely, beginning
from the start. If the tank had already been filled with
water during the previous cycle, the water intake phase
will be omitted from the new programme.
4 To restart the cycle, press the “Start / Pause” button
again.
The End of the Programme
Washing programmes are completed automatically. The word
END appears on the display and the "Time Remaining" light goes
out.
1 Switch the appliance off by turning the “Programme
Selector” knob to “OFF “
2 Unload the laundry from the drum.
3 Leave the door ajar to allow the interior of the washing
machine to dry out.
4 Turn off the water intake tap.
If during the initial spin speed setting stage, the "no spin" mode
(spin speed set as “0”) was selected, at the end of the washing
programme the word “STOP” appears on the display, alternating
with “----“ (spin speed of “0”), the spin light stays on.
To proceed with the pump-out and spin, press the spin selection
button twice. The appliance restarts the cycle with the pump-out
and spin. To select the spin speed required, press the button until
the chosen speed is displayed. To pump out the water from the
tank without performing the spin, press the spin selection button
until the display indicates speed of 0: the pump-out will be run
without spin.
To Next Page
Loading...
