CDA ci261

28
Fault
Possible Causes
Suggested Actions
Excessive foam is
formed in the
detergent drawer
Too much detergent used
Press “Start/Pause”
button. To eliminate foam
formation, mix a spoon of
softener with a half litre of
water, and pour the
mixture into the detergent
drawer. After 5-10
minutes, press the
“Start/Pause” button
again. In next washing
operation reduce the
dose of detergent used.
Wrong detergent used Use only detergents
designed specifically for
automatic washing
machines
Feet of the machine are
not adjusted
Adjust the machine feet
Transit bolts not removed
Remove the transit bolts
Load in machine is too
small
This will not prevent use
of the machine
The machine vibrates Machine overloaded, or
load is unbalanced
Do not load more than
the recommended weight
of washing into the
machine. Ensure the load
is evenly distributed
Machine is standing too
close to a wall
Leave minimum 2cm
space between your
machine and all walls or
hard surfaces
Machine empties as
soon as it has filled
with water
The end of the water
discharge hose is too low
Set the discharge hose at
the appropriate height
No water appears in
drum during washing
Not a fault, water should
only be in the non-visible
part of the drum
None required
Washing has detergent
residues on it
Non-dissolving particles of
some detergents may
adhere to your washing
Set the machine to do an
extra rinse programme, or
brush the spots off after
the washing is dry