Programme selection
To select a programme, turn the “Programme Selector” knob to the required programme, as detailed in the
programme listing below and also on the detergent dispenser. The display will show the programme
duration.
Spin speed selection
Each selected programme has its own preset spin speed as shown in the programme listing below. If you
press the “Spin speed” button the currently set spin speed will show on the display. You can reduce this or
switch it off completely if required by pressing the “Spin speed” button a number of times. If you miss the
speed you want you can come back round to it again by pressing a few more times.
A programme without final spin is used to prevent creasing when washing special fabrics.
Wash temperature selection
Each selected programme has its own preset wash temperature, as shown in the programme listing below.
If you press the “Wash Temperature” button the currently set temperature will show on the display. You can
change the wash temperature if required by pressing the “Wash temperature” button a number of times.
Extra functions
Extra functions can be selected once the programme has been set. To select any extra function, press the
required extra function button. The programme time shown on the display will reduce or increase according
to the extra functions selected.
Delay timer
A delay of up to 24 hours can be added to the end time in half hour increments to allow the wash
programme to finish at a convenient time. The delay time is to the end of the wash programme not the start
of the programme. The “Delay Timer” function is not available for the “Spin” programme.
To set the delay timer
• Press the “Delay Timer” button.
• Pressing the “Delay Timer” button again increases the delay by 30 minutes for each press, up to a
maximum of 24 hours.
• Once the required time delay is shown on the display, the washing machine will set after approximately
three seconds delay.
To Next Page
Loading...
