CDA WC461

14
Failure Codes and Troubleshooting
The programme indicators also serve as a diagnostic display to help in the event of a problem with the appliance.
Error Code Error description Advice
F1 Alarm is active against water overflow
• Turnoffthedishwasheranddisconnectthewatersupply
• ContactCDACustomerCare
F2
The waste water in the machine
cannot be discharged.
• Drainhoseisblocked
• Theltersofyourmachinemightbeblocked
• Restartthedishwasherandcanceltheprogramme
• Iftheerrorcontinues,contactCDACustomerCare
F3 Continual fill error. • ContactCDACustomerCare
F5 Inadequate water supply.
• Makesurethewatertapisfullyopen
• Closethewatertap,separatethewaterinlethosefromthetap
and clean the filter.
• Restartthedishwasher.
• Iftheerrorcontinues,contactCDACustomerCare
F6 Faulty heater sensor. • ContactCDACustomerCare
F7
Overheating error (temperature in the
machine is too high).
• ContactCDACustomerCare
F8 Heater error. • ContactCDACustomerCare
F9 Spray diverter position error. • ContactCDACustomerCare
FE Faulty electronic card. • ContactCDACustomerCare