CDVI CDV-DDP-F User Manual

EN EN
11
CDV-DDP-F, CDV-DDP-RH
2EASY 2-wire Video Door Station with Built-in Reader
8] CODE UNLOCK FUNCTION
[ - - - - ]
Please Input Password
1 2 3
654
7 8 9
#0
*
RF CARD
1 2 3
654
7 8 9
#0
*
RF CARD
[8017 ]
i
Door Open
Refer to the following operations:
When the Door Station
is in standby, Press “#”.
Enter 4 digits Unlock
Code directly.
If veried correctly, the
door opens.
Changing the Unlock Code
If the door station is in Debug State press “1#” to activate Tools Menu, then select “2”
to enter setup page. Finally, select 4.
When the door station is in standby mode follow the steps below:
[ 8002 ]
Please Input Password
1 2 3
654
7 8 9
#0
*
RF CARD
*Cancel
Long press[ ] to enter private code setting
[ - - - - ]
( * * * *)
# Save
4. Unlock Code[1111]
1. Language [1]
3. Tone Volume[03]
4. Unlock Code [1111]
5. Work Mode
6. Clock
7. Setup Code
8. About
9. Default
Press No.
to select
*Back
Setup
2. Tone Select [03]
Press “#”, Enter “8002”,
then enter Setup Code or
Admin Code (88888888
or 66666666 by default)
Press “4” to enter unlock
code item.
Enter 4 digits number,
then press “#” to update
4. Unlock Code [1111]
[----]
(****)
[005]
Input setting code
[009]
Input room number
Setting code: 005
RF CARD
4. Unlock Code
4. Unlock Code [---] [----]
[8888]
Input new password
Setting code: 005
4. Unlock Code [009] [----]
[8888]
Input new password
Setting code: 005
4. Unlock Code [009] [8888]
*Cancel # Save *Cancel # Save *Cancel # Save *Cancel # Save *Cancel # Save
Long press[ ] to enter private code setting Long press[ ] to enter public code setting
At this point you can also set the Private Unlock Code by following these steps:
Long press
button
Enter setting code
(001~200), then
press # to save.
Input room
number, then
press # to save.
Input new
password, then
press “#“ to save.

CDVI CDV-DDP-F Specifications

General

Brand	CDVI
Model	CDV-DDP-F
Category	Intercom System
Language	English