CDVI Galeo - Reset Master Code and User Codes



 

   
  
 
  
 
 
  
  Onebeepisemitted.Presson
  andtoconrmresetofallmemory
  ofthekeypad.Waitfortwobeeps.
  Themastercodeisrestored
  toitsdefaultvalue
  andalltheUsercodesaredeleted
  fromthekeypad.Oncethereset
  iscompletedthenthekeypadreturns
  toastand-byoperatingmode.

  
  
  
 
Twobeepsareemittedtoconrmreset
  ofthekeypad.RemoveP2jumper.
  Themastercodeisrestoredtoitsdefault
  valueandalltheUsercodes
  aredeletedfromthekeypad.


  
  (defaultvaluemastercode).
  2beepsareemittedtoconrm 
  entryinprogrammingmode.
  

 Onebeepisemitted.Press4or5
  forthedigitcode.Onebeepisemitted
  toconrmprogrammingofthecodelength.


   
  Onebeepisemitted.Enterthenew4
  or5-digitmastercode.Onebeepis
  emittedtoconrmprogramming
  ofthenewmastercode. 
  
  
  2beepsareemittedtoconrmthatthekey-
  padisinstand-byoperatingmode.



 

  
  
  (defaultvaluemastercode).
  2beepsareemittedtoconrm 
  entryinprogrammingmode.
    
  Onebeepisemitted.Enterthenew4or5
  digitmastercode. Onebeepisemitted
  toconrmthatthemastercodeisprogrammed.

-Withoutcodes.
-Illuminationtime:10seconds.
-Relayreleasetime:1second.
-Codelength:5-digit.
-MasterCode:.
-Programmingsecuritytime :
 120 secondes.
- Codelengthforsubmastercode:
 Version 1 relay (Group 1) =
A and B,
Version 2 relays (Group 2) =
1 and 3
Version 3 relays (Group 3) =
4 and 6.

Thebuzzerindicatesdifferent
audiblesignals.Itcanbeturned
offbycuttingtheST1wireonthe
remotecontroller
Keypadpowered
datacomputingin
programmingoraccessgranted
EnterorExitfrom
programming
datacomputing
error.

ThemastercodeandtheUsercodes
canbeof4or5-digitinlength.
Allthekeypadkeyscanbeusedto
programacode.Themastercodeand
thePincodecanbeof4or5-digit
code.ThemastercodeCANNOTbe
usedasaPINcode(UserPincode).
ThemastercodeCANNOTbeusedas
aPINcode(UserPincode).Todelete
aspecicUserpinCodereplaceitby
0000ifcodelengthis4-digitformat
orreplaceitby00000ifthecodeisin
5-digitformat.

Resetmastercode
andusercodes

modicationofindividual
codebytheuser

IlluminatedWeatherproofKeypadwithremoteelectronics
 
10
cdvi.se
cdvigroup.com